Control Module Communication

Control module communication

Checking the wiring




- Ignition off
- The breakout box connected.
Check the communication cable between transmission control module (TCM) terminal #27 and engine control module (ECM) terminal #27. Check for an open-circuit according to Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault. Check for a short-circuit to ground according to Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault. Check for a short-circuit to supply voltage according to Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault.
Check the communication cable between transmission control module (TCM) terminal #26 and engine control module (ECM) terminal #57. Check for an open-circuit according to Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault. Check for a short-circuit to ground according to Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault. Check for a short-circuit to supply voltage according to Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault.
Remedy as necessary.

Other information:
- To connect the breakout box to the transmission control module (TCM) and engine control module (ECM), see Connecting the breakout box, AW55-50/51SN Connecting The Breakout Box
- For information about transmission control signals, see Signal description. Transmission control module (TCM), AW55-50/51SN Signal Description
- For information about engine control module (ECM) (turbocharged engines) signals, see Signal specification Signal Specification.









Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Checking the wiring

-------------------------------------------------