Temperature Too High

Temperature too high

Checking the oil cooler and hoses
The cause of the diagnostic trouble code (DTC) was insufficient oil cooling in the transmission. Check the oil cooler and hoses for signs of damage and blockage. Then replace the oil.

Other information:
- To replace the oil, see Oil, changing, AW55-50/51SN Changing Oil.

Continue - Resetting the oil quality counter

-------------------------------------------------

Resetting the oil quality counter





Resetting the "Transmission fluid change" counter

Resetting the "Transmission fluid change" counter

Hint: The transmission control module (TCM) has a counter for the oil quality. The counter counts up if the transmission is exposed to too high a load or an ambient temperature that is too high. If the counter is not reset when the oil is drained or changed, there is a risk that a diagnostic trouble code (DTC) will be stored incorrectly. Therefore it is important that the "Transmission oil change" counter is reset.

Note! This only applies when the transmission fluid is changed and when the fluid is changed during repairs to the transmission temperature sensor.




- Ignition on.
Click on the VCT2000 symbol to reset the counter.





Continue - DONE

------------------------

DONE - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reconnect the connectors. Reinstall the components
- Test drive the car according to Test drive schedule, description, AW55-50/51SN Test Drive Schedule, Description.





Is the function of the transmission OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Fault-tracing information

VERIFIED - FAULT FOUND

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the oil cooler and hoses

-------------------------------------------------