Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information

Condition
The control module checks for misfiring after the engine's first 1000 crankshaft revolutions after starting. Diagnostic trouble code (DTC) ECM-45 is stored if the control module registers a misfire which causes increased emissions.

Substitute value
- Fuel trim disabled.
- Three-way catalytic converter (TWC) diagnostic disabled.
- Knock retardation disabled.
- Idle air trim adaptation is disabled.
- Evaporative emission (EVAP) system operates at minimum.

Possible source
- Fuel stoppage.
- Repeated cold starting where the engine coolant temperature (ECT) has not reached normal operating temperature between starts.
- Water in spark plug wells.
- Defective spark plugs, ignition cables, ignition coil or flywheel / pulse wheel.
- Contaminated fuel or incorrect fuel type.
- Blocked / leaking injector.
- Intermittent open-circuit, intermittent short-circuit to ground, intermittent short-circuit to voltage supply, contact resistance or loose connection in the ignition system low-tension side, in the injector circuit or fuel pump (FP) circuit.
- Blocked crankcase ventilation.
- Damaged VVT-unit.
- Moisture, flashover in the ignition system on HT side.
- Leakage between cooling system and cylinder.
- Uneven compression.

Fault symptom[s]
- Engine difficult to start.
- The engine runs unevenly at idle or there are marked jerks in engine response when driving.
- Poor performance.
- High emissions.