Verification

Verification







HINT: After carrying out the repair, check that the fault has been remedied as follows:
- Ignition off.
- Reinstall the connectors, components etc.
- Disconnect the VCT 2000 from the data link connector (DLC).
- Ignition on.
- Test drive the car. Do not switch off the engine after the test drive.
- Connect VCT 2000 to the data link connector (DLC) in the car.
- Read off the diagnostic trouble codes (DTCs). Check whether diagnostic trouble code (DTC) 2-1-1 has been stored.

Was this diagnostic trouble code (DTC) stored?

YES: See Fault-Tracing Information - Permanent Fault. Fault-Tracing Information - Permanent Fault
NO: Refer to Trouble Code Descriptions. Diagnostic Trouble Code Descriptions