Signal Too Low
Signal too low
Status check
- Ignition on
- Read off the signals from the clock adjustment knob.
Check the clock adjustment knob signals. Compare the signals with the values summarized in Description of parameters Description Of Parameters.
Are the values for the clock adjustment knob signals incorrect?
Yes - Replacing the component
No - Information
-------------------------------------------------
Replacing the component
Replace the combined instrument panel according to Driver information module (DIM), installation/removal, component replacement Removal and Replacement.
Continue - Verification
-------------------------------------------------
Verification
Verification
Hint: After carrying out the repair, check that the fault has been remedied.
- Ignition off
- Reinstall the connectors, components etc.
- Ignition on
- Read off the signals from the clock adjustment knob.
Check the clock adjustment knob signals. Compare the signals with the values summarized in Description of parameters Description Of Parameters.
Does the clock adjustment knob position correspond with the noted values?
Yes - VERIFIED
No - VERIFICATION FAILED
------------------------
VERIFIED - FAULT FOUND
VERIFICATION FAILED - Fault-tracing information
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.
Do you want to exit fault-tracing?
Yes - Exit fault-tracing
No - Attempt New Test
------------------------
Attempt New Test - Replacing the component
-------------------------------------------------
Information
The combined instrument panel has previously registered a fault in the clock adjustment signal, but registers that the fault no longer exists.
Continue - Fault-tracing information
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).
Do you want to view the information again?
Yes - Attempt New Test
No - FAULT FOUND
------------------------
Attempt New Test - Information
FAULT FOUND - DONE
-------------------------------------------------