Signal Too High. Permanent Fault

Signal too high. Permanent fault

Checking components and wiring
Check the cable between the engine control module (ECM) terminal #B41 (#B51) and combined instrument panel terminal #B1 (terminal #31). Check for a short-circuit to supply voltage according to Checking wiring and terminals. Permanent fault Checking Wiring and Terminals. Permanent Fault.
Remedy as necessary.

Other information:
- To connect the engine control module (ECM) breakout box, see Connecting the breakout box, B5234T9, B5244T7 Connecting The Breakout Box
- To connect the combined instrument panel breakout box, see
- To access and replace the combined instrument panel, see Driver information module (DIM), replacing Driver Information Module (DIM), Replacing
- For information about signals, see Signal specification Signal Specifications.










Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.




- Ignition off.
- Reinstall connectors, components etc.
- Start the engine.
- Activate ETS lamp.
- Check that function is OK.









Is the function OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking components and wiring

-------------------------------------------------