Checking/Replacing Operating Switch

Checking/replacing operating switch

Checking operating switch




- Remove the courtesy light, see Removing/installing courtesy light Removing/Installing Courtesy Light.
- Switch on the ignition.
- Connect a cable between connection 6 and 4 (open to the tilt position) or between connection 6 and 8 (close from the tilt position).
Slide and tilt roof works; switch is faulty.
- Install the courtesy light, see Removing/installing courtesy light Removing/Installing Courtesy Light.

Replacing operating switch
The switch is an integral part of the courtesy lighting panel and must therefore be replaced completely. See section 3.