Connecting The Breakout Box
Connecting the breakout box
951 1355 Adapter 42-pin 951 1355 Adapter 42-pin 981 3190 Replaced by 9511428 981 3190 Replaced by 951 1428
Information
Connecting the breakout box to AW50-42
Is the breakout box connected to the control module?
Yes - CONNECTEDReturn to fault-tracing.
No - NOT CONNECTED
------------------------
CONNECTED - CONNECTED
NOT CONNECTED - Connecting the breakout box
-------------------------------------------------
Connecting the breakout box
Connecting the breakout box
981 3190 Replaced by 9511428 981 3190 Replaced by 951 1428 951 1355 Adapter 42-pin 951 1355 Adapter 42-pin
Connecting the breakout box
Caution! The voltage supply to the control module must be disconnected when disconnecting the breakout box. Failure to observe this procedure could seriously damage the control module.
- Ignition off
- Expose and disconnect the AW50-42 transmission control module (TCM) according to Replacing the transmission control module (TCM), AW50-42 Service and Repair.
- Control module disconnected.
Connect adapter 951 1355 Adapter 42-pin 951 1355 Adapter 42-pin to the control module connector (wiring side). Connect breakout box 981 3190 Replaced by 9511428 981 3190 Replaced by 951 1428 to the adapter.
Note! Ensure that the adapter is the right way around.
Select Continue.
Continue - DONE
------------------------
DONE - Checking the ground terminal
-------------------------------------------------
Checking the ground terminal
- Ignition off.
- Control module disconnected.
- Switch off all power consuming equipment, such as courtesy lighting, radio etc.
Connect an ohmmeter between terminal 1 on the breakout box and the battery negative terminal.
The ohmmeter should read approximately 0 ohms.
OK - Return to the fault-tracing procedure where it was interrupted.
No Fault Found
Not OK - Checking for an open-circuit, contact resistance and oxidation
-------------------------------------------------
Checking for an open-circuit, contact resistance and oxidation
Check ground terminal 31/20 and the lead between the ground terminal and control module #1 for open-circuit according to Checking wiring and terminals. Permanent fault Checking Wiring And Terminals. Permanent Fault and contact resistance and oxidation according to Checking wiring and terminals. Permanent fault Checking Wiring And Terminals. Permanent Fault.
Check the ground lead between the battery and the body for an open-circuit according to Checking wiring and terminals. Permanent fault Checking Wiring And Terminals. Permanent Fault and contact resistance and oxidation according to Checking wiring and terminals. Permanent fault Checking Wiring And Terminals. Permanent Fault.
Select Continue when the fault has been remedied.
Continue - Verification
-------------------------------------------------
Verification
Verification
Verification
Hint: After repairs have been completed they must be verified as follows to ensure that the fault has been eliminated:
- Ignition off
- Switch off all power consuming equipment, such as courtesy lighting, radio etc.
- Control module disconnected
Connect an ohmmeter between #1 on the breakout box and the battery negative terminal.
The ohmmeter should read approximately 0 ohms.
OK - VERIFIED
Not OK - VERIFICATION FAILED
------------------------
VERIFIED - FAULT FOUND
VERIFICATION FAILED - Fault-tracing information
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
The fault should be diagnosed and remedied. Since this is not the case the fault-tracing process has failed.
Complete the fault-tracing for those fault or try again.
Do you want to terminate fault-tracing at this time?
Yes - FAULT-TRACING FAILED
No - Attempt New Test
------------------------
Attempt New Test - Connecting the breakout box
FAULT-TRACING FAILED - FAULT-TRACING FAILED
-------------------------------------------------