Spacer Ring

Spacer Ring

Replacing the spacer ring

Special tools: 999 5604

Removal







- Remove the clutch driven plate according to Magnetic clutch.
- Remove the snap ring.
- Remove the spacer ring from the shaft.
- Install the special tool 999 5604 in the socket. Turn the tool 90 degrees.
- Pull the spacer ring sleeve out to the right.

NOTE: Clean all components with compressed air and a lint-free cloth.

- Check whether any components are worn or dirty. This is particularly important if remnants of the spacer ring remain.

Hint: To replace the spacer ring, see Installing the spacer ring.

NOTE: Do not touch the inner runner section or the carbon section with your fingers.







- Apply compressor oil on all mating surfaces in the spacer ring.
- First install the spacer ring on special tool 999 5604.
- Carefully position the tool and the spacer ring on the shaft. Do not turn it.
- Press the spacer ring into place.

Finishing

Installation







- The wedge in the shaft.
- The adjustment rings.
- The felt spacer rings and the holder (the holder must be at exactly the same level as the sleeve). Use a drift and a cover.