Signal Too High. Intermittent Fault

Signal too high. Intermittent fault

Checking the component and wiring








- disconnect the driver's airbag connector
- Ignition on.
Connect an oscilloscope between driver's airbag terminals #1 and #2. Check for an intermittent short-circuit to supply voltage according to Checking wiring and terminals. Intermittent faults Checking Wiring And Terminals. Intermittent Faults.
The oscilloscope should now display a spiked pulse with an interval of approximately 500 ms.
Also take a reading between ground and airbag terminal #2. The oscilloscope should not give any reading.
The cable harness should be replaced in the event of a fault in the wiring. No repairs may be made to the cable harness.
Remedy as necessary.

Note! Diagnostic trouble code (DTC) SRS-0079 is stored after this reading has been taken. Ignore the diagnostic trouble code (DTC), which is stored due to this operation.

Other information:
- To access the driver's airbag, see Steering wheel module, steering wheel and contact reel, replacement Airbag Driver's Side (SRS), Replacing.









Select Continue when the fault has been remedied.

Continue - Fault-tracing information
DONE

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

FAULT-TRACING FAILED - DONE

FAULT FOUND - FAULT FOUND

Attempt New Test - Checking the component and wiring

-------------------------------------------------