Signal Too High. Intermittent Fault

Signal too high. Intermittent fault

Checking the connectors and the cable












- Make a note of the anti-theft radio code
- Ignition off
- Disconnect the battery negative lead
- Disconnect the control module.
Connect an ohmmeter between control module terminal #25 and terminal #5 for the control module battery voltage. Check for an intermittent short-circuit to supply voltage according to Checking wiring and terminals. Intermittent faults Checking Wiring And Terminals. Intermittent Faults.
Remedy as necessary.

Other information:
- To access and replace the control module, see Sensor module, replacement Service and Repair.





Select Continue when the fault has been remedied.

Continue - Fault-tracing information
DONE

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

FAULT-TRACING FAILED - DONE

FAULT FOUND - FAULT FOUND

Attempt New Test - Checking the connectors and the cable

-------------------------------------------------