Faulty Signal. Intermittent Fault

Faulty signal. Intermittent fault

Checking the connector and cable












- Ignition off.
- Disconnect combined instrument panel connector B.
- Disconnect the control module.
Check the control module terminal pins for contact resistance and oxidation according to Checking wiring and terminals. Intermittent faults Checking Wiring And Terminals. Intermittent Faults.
Check the cable between combined instrument panel #B11 and control module #25, measure for an intermittent open-circuit according to Checking wiring and terminals. Intermittent faults Checking Wiring And Terminals. Intermittent Faults and an intermittent short-circuit to ground according to Checking wiring and terminals. Intermittent faults Checking Wiring And Terminals. Intermittent Faults.
Remedy as necessary.













Other information:
- To disconnect / replace the control module, see Sensor module, replacement Service and Repair.
- To access / replace the combined instrument panel, see Driver information module (DIM), installation/removal, component replacement Driver Information Module (DIM), Installation/Removal, Component Replacement.

Select "Continue" when the fault has been remedied.

Continue - Fault-tracing information
DONE

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

FAULT-TRACING FAILED - DONE

FAULT FOUND - FAULT FOUND

Attempt New Test - Checking the connector and cable

-------------------------------------------------