Incorrect MIN Code

Incorrect MIN code

Checking start




Try to start the engine.

Does the engine start?

Yes - Fault-tracing information

No - Checking the fault cause

-------------------------------------------------

Fault-tracing information
The cause of the fault was a temporary disruption of communication or that the engine control module (ECM) installed in the car did not correspond to the immobilizer control module it is programmed.

Select Continue.

Continue - Verification

-------------------------------------------------

Checking the fault cause
Check which fault source corresponds with the circumstances.
1. A new immobilizer control module has been installed in the car.
2. A engine control module (ECM) not intended for the engine in the car has been installed.

Select one of the following options to continue.

1 - Initiating the immobilizer control module

2 - Wrong type of engine control module (ECM)

-------------------------------------------------

Initiating the immobilizer control module
The incorrect engine selection was made when initiating the control module. Try a new control module according to Immobilizer control module Immobilizer Control Module.
Initiate the immobilizer control module according to Immobilizer control module, initiating Immobilizer Control Module, Initiating.

Select Continue.

Continue - Verification

-------------------------------------------------

Wrong type of engine control module (ECM)

Hint: If the problem occurred when another engine control module (ECM) was installed, the immobilizer will not recognize the MIN code. For technical reasons the engine control module (ECM) from another engine type cannot be used for repairs.

Check carefully that the engine control module (ECM) is the correct one for the engine type.

Select Continue.

Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: Check that the repair has been successful and that the fault has been remedied as follows.




- Switch the ignition off and on.
- Erase diagnostic trouble codes (DTCs).
Try to start the car.





Does the car start?

Yes - VERIFIED

No - Verification (continued)

------------------------

Verification (continued)




- Switch off the ignition for at least 3 seconds.
- Ignition on.
Read off diagnostic trouble codes (DTCs).





Has the diagnostic trouble code (DTC) been stored again?

Yes - VERIFICATION FAILED

No - VERIFIED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

Attempt New Test - Checking start

FAULT-TRACING FAILED - FAULT-TRACING FAILED

-------------------------------------------------