Not Programmed
Not programmed
IMM-132 Key codes
Checking initiation
- Ignition on.
Check if the immobilizer is initiated by reading off the IMMO STATUS parameter.
Is the NORMAL parameter displayed?
Yes - Programming keys
No - Initiation
-------------------------------------------------
Programming keys
- Program the car keys according to Add/delete key Add/Delete Key.
- Ignition on.
- Erase diagnostic trouble codes (DTCs).
Select Continue.
Continue - Reading off diagnostic trouble codes (DTCs)
-------------------------------------------------
Initiation
Initiate the immobilizer control module according to Immobilizer control module, initiating Immobilizer Control Module, Initiating.
Select Continue.
Continue - Reading off diagnostic trouble codes (DTCs)
-------------------------------------------------
Reading off diagnostic trouble codes (DTCs)
- Ignition off.
- Ignition on.
Read off diagnostic trouble codes (DTCs).
Has diagnostic trouble code (DTC) IMM-132 been stored again?
Yes - Replacing the control module
No - Fault-tracing information
-------------------------------------------------
Replacing the control module
Try a new control module according to Immobilizer control module Immobilizer Control Module.
Initiate the new control module according to Immobilizer control module, initiating Immobilizer Control Module, Initiating.
Select Continue.
Continue - Verification
-------------------------------------------------
Fault-tracing information
The keys are programmed into the immobilizer control module memory.
Select Continue.
Continue - Verification
-------------------------------------------------
Verification
Verification
Verification
Hint: Check that the repair has been verified and that the fault has been remedied as follows.
Does the car start with all keys?
Yes - VERIFIED
No - VERIFICATION FAILED
------------------------
VERIFIED - FAULT FOUND
VERIFICATION FAILED - Diagnostic trouble code (DTC) information
-------------------------------------------------
Diagnostic trouble code (DTC) information
Information
Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.
Do you want to exit fault-tracing?
Yes - FAULT-TRACING FAILED
No - Attempt New Test
------------------------
FAULT-TRACING FAILED - FAULT-TRACING FAILED
Attempt New Test - Checking initiation
-------------------------------------------------