Operation CHARM: Car repair manuals for everyone.
Hosted by mcallihan.com

Signal Too Low






Signal too low

Checking engine coolant temperature (ECT) sensor function




- Ignition on.
- Read off coolant temperature.
Check the engine coolant temperature (ECT) reading is correct. Compare with the actual coolant temperature of the engine.





Is the temperature reading OK?

Yes - Intermittent fault

No - Checking component and cables

-------------------------------------------------

Checking component and cables
Check engine coolant temperature sensor resistance. For resistance values refer to Component resistance values Component Resistance Values.
Check cable between control module #16 and the engine coolant temperature (ECT) sensor signal connection for a short-circuit to ground according to Checking wiring and terminals. Permanent fault Checking Wiring And Terminals. Permanent Fault.

Hint: Because it is difficult to separate the engine coolant temperature sensor ground lead from the signal cable, one must measure one cable at a time and see if the permitted values are present on either of them.

Remedy as necessary.

Other information:
- To access the control module/connect breakout box
- To access/replace Coolant temperature sensor see Overheating protection thermostat, flame sensor and Coolant temperature sensor, replace Replacing Overheat Protection, Thermostat Flame Sensor And Coolant Temperature Sensor.
- With ignition on and engine coolant temperature sensor signal cable cut the voltage between engine coolant temperature sensor signal cable (engine control module (ECM) side) and ground should be approximately 5 V.
- For other values, see Signal specification Additional heater 912-D/B Signal Specification Additional Heater 912-D/B.













Select Continue.

Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off.
- Reinstall connectors, components etc.
- Ignition on.
- Read off coolant temperature.
Check the engine coolant temperature (ECT) reading is correct. Compare with the actual coolant temperature of the engine.





Is the temperature within its permitted range?

Yes - VERIFIED

No - VERIFICATION FAILEDPAPER

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - FAULT-TRACING FAILED

Attempt New Test - Checking engine coolant temperature (ECT) sensor function

-------------------------------------------------

Intermittent fault
Check cable between control module #16 and engine coolant temperature sensor signal terminal for an intermittent short-circuit to ground according to Checking wiring and terminals. Intermittent faults Checking Wiring And Terminals. Intermittent Faults.
Remedy as necessary.

Other information:
- To access the control module/connect breakout box
- To access/replace Coolant temperature sensor see Overheating protection thermostat, flame sensor and Coolant temperature sensor, replace Replacing Overheat Protection, Thermostat Flame Sensor And Coolant Temperature Sensor.
- For other values, see Signal specification Additional heater 912-D/B Signal Specification Additional Heater 912-D/B.













Select Continue.

Continue - Fault-tracing information
DONE

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Checking engine coolant temperature (ECT) sensor function

FAULT-TRACING FAILED - DONE

FAULT FOUND - FAULT FOUND

-------------------------------------------------