Signal Too High. Permanent Fault

Permanent fault, signal too high

Checking air conditioning (A/C) relay








- Ignition off
- Disconnect air conditioning (A/C) relay 2/10.
Connect an ohmmeter between the air conditioning (A/C) relay terminals 1 and 2 (relay side).









The ohmmeter should read approximately 105 ohms at +20°C

OK - Checking the signal cable

Not OK - Defective air conditioning (A/C) relay

-------------------------------------------------

Checking the signal cable




- Ignition on.
Check the cable between the engine cooling fan (FC) relay base terminal 2 and the engine control module (ECM) connector terminal 68 for a short-circuit to supply voltage according to Checking wiring and terminals. Permanent fault Checking Wiring And Terminals. Permanent Fault.
Remedy as necessary.













Select Continue.

Continue - Verification

-------------------------------------------------

Defective air conditioning (A/C) relay
Try a new air conditioning (A/C) relay.

Select Continue.

Continue - Verification

-------------------------------------------------

Verification








- Reconnect the connectors, reinstall components etc.
- Connect VCT 2000
- Ignition on.
Activate the air conditioning (A/C) relay by clicking the VCT 2000 symbol.





Does the air conditioning (A/C) relay click?

Yes - FAULT FOUND

No - No Fault FoundFault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - FAULT-TRACING FAILED

Attempt New Test - Checking air conditioning (A/C) relay

-------------------------------------------------