No Data
No data
Checking data
Check that the following parameters are programmed:
- Mileage to service.
- Engine hours to service.
- Time remaining until service.
- Speedometer, calibration.
Select "Continue" to read off and program parameters.
Continue - ???
-------------------------------------------------
Reading off the programmed values
Information about reading off parameters
Before the control module is replaced it is vital that the programming is read off the old combined instrument panel.
Read off the programmed values in the old control module. Note the values.
If it is not possible to read off the values, consult the either the manager, the sales company or the customer so that the new control module is programmed with the same values as the old control module.
Reading off is divided into two sections; one section for the parameters that can be programmed and one section for the parameters that are factory programmed or programmed by the manufacturer.
Select one of the following functions:
1. Read off the customer programmed values, instruments only calibrated in kilometers
2. Read off the customer programmed values, instruments calibrated in both miles and kilometers
3. Read off the factory programmed values
4. Finish reading off.
1 - Checking the programmed values, calibrated only in kilometers
2 - Checking the programmed values, calibrated in both miles and kilometers
3 - Checking the factory programmed values
4 - DONE
------------------------
Checking the programmed values, calibrated only in kilometers
- Ignition on.
Click on the VCT2000 symbol to read off the programmed values
For information about the programmed values, see Description of programmed data Description Of Programmed Data.
Select Continue.
Continue - Information about reading off parameters
------------------------
Checking the programmed values, calibrated in both miles and kilometers
- Ignition on.
Click on the VCT2000 symbol to read off the programmed values
For information about the programmed values, see Description of programmed data Description Of Programmed Data.
Select Continue.
Continue - Information about reading off parameters
------------------------
Checking the factory programmed values
- Ignition on.
Click on the VCT2000 symbol to read off the programmed values
For information about the programmed values, see Description of programmed data Description Of Programmed Data.
Select Continue.
Continue - Information about reading off parameters
------------------------
DONE - Fault-tracing information
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.
Do you want to view the information again?
Yes - Attempt New Test
No - FAULT FOUND
------------------------
FAULT FOUND - FAULT FOUND
Attempt New Test - Checking data
-------------------------------------------------