Signal Too Low

Signal too low

Status check




- Ignition on.
- Read off the reset button position.
Compare the reset button position with the noted value.
- ON=Reset depressed
- OFF=Reset button unaffected





Does the reset button position correspond with the noted value?

Yes - Information

No - Replacing the component

-------------------------------------------------

Replacing the component
Replace the combined instrument panel according to Driver information module (DIM), installation/removal, component replacement Driver Information Module (DIM), Installation/Removal, Component Replacement.





Select Continue.

Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After carrying out the repair, check that the fault has been remedied.




- Ignition off.
- Reinstall the connectors, components etc.
Compare the reset button position with the noted value.
- ON=Reset depressed
- OFF=Reset button unaffected





Does the reset button position correspond with the noted values?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - FAULT-TRACING FAILED

Attempt New Test - Replacing the component

-------------------------------------------------

Information
The combined instrument panel had previously registered that the trip odometer reset button had been in the reset position for longer than 25 seconds, but registers that the fault no longer exists.





Select Continue.

Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Information

FAULT FOUND - DONE

DONE - DONE

-------------------------------------------------