Signal Too Low

Signal too low

Status check




- Ignition on.
- Read off the reset button position.
Compare the reset button position with the noted value.
- ON=Reset depressed
- OFF=Reset button unaffected





Does the reset button position correspond with the noted value?

Yes - Checking components and wiring

No - Checking components and wiring

-------------------------------------------------

Checking components and wiring

Hint: If the cable and the combined instrument panel are fault free the voltage between terminals 4 on the connector to the trip computer control panel and ground should be approximately Ubat V.

Check the signal cable between the trip computer control panel terminal 4 and the combined instrument panel terminal A24(#A24) for a short-circuit to ground according to Checking wiring and terminals. Permanent fault Checking Wiring And Terminals. Permanent Fault.
Remedy as necessary.

Other information:
- To connect the breakout box,
- To access / replace the combined instrument panel, see Driver information module (DIM), installation/removal, component replacement Driver Information Module (DIM), Installation/Removal, Component Replacement.
- To access / replace the trip computer control panel,
- For information about signals, see Signal specification Signal Specification.













Select Continue.

Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After carrying out the repair, check that the fault has been remedied.




- Ignition off.
- Reinstall the connectors, components etc.
Compare the reset button position with the noted value.
- ON=Reset depressed
- OFF=Reset button unaffected





Does the reset button position correspond with the noted values?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - FAULT-TRACING FAILED

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - FAULT-TRACING FAILED

Attempt New Test - Checking components and wiring

-------------------------------------------------

Checking components and wiring

Hint: If the cable and the combined instrument panel are fault free the voltage between terminals 4 on the connector to the trip computer control panel and ground should be approximately Ubat V.

Check the signal cable between the trip computer control panel terminal 4 and the combined instrument panel terminal A24 (#A24) for an intermittent short-circuit to ground according to Checking wiring and terminals. Intermittent faults Checking Wiring And Terminals. Intermittent Faults.
Remedy as necessary.

Other information:
- To connect the breakout box,
- To access / replace the combined instrument panel, see Driver information module (DIM), installation/removal, component replacement Driver Information Module (DIM), Installation/Removal, Component Replacement.
- To access / replace the trip computer control panel,
- For information about signals, see Signal specification Signal Specification.













Select Continue.

Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Checking components and wiring

FAULT FOUND - DONE

DONE - DONE

-------------------------------------------------