Signal Too Low. Intermittent Fault

Signal too low. Intermittent fault

Replacing the component




The control module has registered an internal fault. Try a new control module.

Note! New control modules are delivered with pre-programmed values from the factory. The control module must be programmed with the relevant data for the market, body type etc. in order for it to function correctly after replacement.The programmed values must therefore be read from the existing control module and noted.

- Ignition on.
- Read off the values programmed into the control module.

Other information:
- To access / replace the central electronic module (CEM), see Replacing central electronic module (CEM) Service and Repair.
- For information about programming, see Description of programmed data Description Of Programmed Data.









Select Continue.

Continue - Fault-tracing information
FAULT FOUND

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Replacing the component

FAULT FOUND - DONE

-------------------------------------------------