Signal Too High. Intermittent Fault

Signal too high. Intermittent fault

Checking the wiring




- Ignition off.
Check the cable between control module connector F terminal #5 (#B5) and the left high beam bulb. Check the cable between control module connector F terminal #14 (#B14) and the right high beam bulb. Check the cable between control module connector P#9 and the relay for auxiliary lamps terminal #5. Check these cables for an intermittent short-circuit to supply voltage according to Checking wiring and terminals. Intermittent faults Checking Wiring And Terminals. Intermittent Faults.

Other information
- To connect the breakout box, see Connecting the breakout box Connecting The Breakout Box. Central Electronic Module (CEM)
- For information about signals see Signal specification Signal Specification. Central Electronic Module (CEM).









Select Continue.

Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Checking the wiring

FAULT FOUND - DONE

-------------------------------------------------