Signal Too High. Intermittent Fault

Signal too high. Intermittent fault

Checking the wiring
Check the cable between control module connector P #12 (#B32) and connector #6 for the fog lamp switch for an intermittent short-circuit to supply voltage according to Checking wiring and terminals. Intermittent faults Checking Wiring And Terminals. Intermittent Faults

Other information
- To connect the breakout box, see Connecting the breakout box Connecting The Breakout Box. Central Electronic Module (CEM).
- For information about signals, see Signal specification Signal Specification. Central Electronic Module (CEM).









Select Continue.

Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Checking the wiring

FAULT FOUND - DONE

-------------------------------------------------