Signal Too Low. Intermittent Fault
Signal too low. Intermittent fault
Checking the wiring
- Ignition off.
Check the cable between control module connector F #10 (#B10) and fuse 14 in the passenger compartment fusebox for an intermittent open-circuit according to Checking wiring and terminals. Intermittent faults Checking Wiring And Terminals. Intermittent Faults.
Check the cable between fuse 14 in the passenger compartment fusebox and windshield wiper motor connector #3, control module connector F #10 (#B10), control module B2 #24 (#A24), control module connector B2 #2 (#A2), control module B1 #12 (#A42) and rear windshield washer fluid pump #1 for a short-circuit to ground according to Checking wiring and terminals. Intermittent faults Checking Wiring And Terminals. Intermittent Faults.
Check the following cables. Check the cable between control module connector B2 #13 (#A13) and connector #1 for the windshield wiper motor. Check the cable between control module connector B2 #11 (#A11) and connector #3 for the rear windshield wiper motor. Check the cable between control module connector B2 #261 (#A26) and connector #2 for the rear windshield wiper motor. Check these cables for a short-circuit to ground according to Checking wiring and terminals. Intermittent faults Checking Wiring And Terminals. Intermittent Faults.
Remedy as necessary.
Other information
- To connect the breakout box, see Connecting the breakout box Connecting The Breakout Box. Central Electronic Module (CEM).
- For information about signals, see Signal specification Signal Specification. Central Electronic Module (CEM).
Select Continue.
Continue - Fault-tracing information
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).
Do you want to view the information again?
Yes - Attempt New Test
No - FAULT FOUND
------------------------
Attempt New Test - Checking the wiring
FAULT FOUND - DONE
-------------------------------------------------