Configuration Fault
Configuration fault
Checking the component
- Ignition off.
Check the control module and SRS system connectors to ensure that no terminal pins are damaged. Also check the wiring.
Check that the correct SRS control module is installed in the car. Read off by clicking the VCT2000 symbol.
Other information:
- To access or replace the control module, see Supplemental restraint system module (SRS), replacing Service and Repair
- For other values, see Signal specification Signal Description, Supplemental Restraint System (SRS) Control Unit.
Continue - Checking the cable
-------------------------------------------------
Checking the cable
- Ignition off.
Note! Check that the connector (violet) is not connected to an airbag. Disconnect the (violet) connector from the airbag on the driver's side.
Warning! Under no circumstances use an ohmmeter or other live measuring instrument to take readings on a disconnected, non-deployed, pyrotechnic airbag. This could deploy the airbag!
Caution! Do not touch the terminal pins in the SRS control module. There is a risk of static discharge. This could damage the SRS control module.
Check the resistance between terminals #9B (37) and #10B (38) in the supplemental restraint system module (SRS) connector. The resistance must be infinite.
Replace the control module if no fault is found.
Other information:
- To access or replace the control module, see Supplemental restraint system module (SRS), replacing Service and Repair
- To access and replace the driver's airbag connector, see Airbag driver and passenger (SRS), replacing Airbag Driver and Passenger (SRS), Replacing
- To access and replace the contact reel, see Contact reel / steering wheel angle sensor, replacing Contact Reel / Steering Wheel Angle Sensor, Replacing
- To connect the breakout box, see Connecting the breakout box Connecting the Breakout Box, Supplemental Restraint System Module (SRS)
- For information about the repair of SRS wiring, see Cable harness SRS system, repair Procedures
- For other values, see Signal specification Signal Description, Supplemental Restraint System (SRS) Control Unit
- Checking wiring and terminals Checking Wiring And Terminals.
Continue - Verification
-------------------------------------------------
Verification
Verification
Hint: After carrying out the repair, check that the fault has been remedied.
- Ignition off
- Disconnect the battery negative lead
- Reinstall the connectors, components etc.
- Ignition on
- Connect the battery negative lead.
Warning! There must not be anyone inside the passenger compartment when the battery is connected.
- Read off diagnostic trouble codes (DTCs).
The fault is no longer present if the diagnostic trouble code (DTC) status is intermittent.
Is the diagnostic trouble code (DTC) intermittent?
Yes - Verification completed
No - Fault-tracing information
-------------------------------------------------
Fault-tracing information
Information
Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.
Do you want to exit fault-tracing?
Yes - Exit Fault-Tracing
No - Attempt New Test
------------------------
Attempt New Test - Checking the component
-------------------------------------------------