Right Rear Motor Cable Replacement

WARNING: Seats with SIPS bag must always have the transport safety device installed in order to avoid accidentally activating the system when working on the seat.


Caution: While carrying out the following operations take care not to alter the position of the seat guide rails relative to one another. If the rails are moved then it will not be possible to reinstall the seat in the vehicle.

Removing

Preparations
- Make a note of radio code if anti-theft coded radio is installed.
- Remove battery negative lead.
- Cars with SIPS airbag: install the safety device for the SIPS bag in accordance with HHB1.
- Remove seat from car.
- Turn seat upside down and place on a clean surface.

Removal of brackets




- Undo the four screws.
- Remove brackets with the three motors.

Removal of right bracket




- Remove seat right bracket which is secured with six screws.

Removing
- Remove screws on drive gear (four screws).
- Remove locking plate.
- Remove drive cable from motor and drive gear.

Reinstalling




- Reinstall drive cable in motor.
- Reinstall right bracket.

Reinstalling brackets
- Reinstall brackets with the three motors.

Reinstalling drive cable
- Replace drive cable in drive gear and tighten locking plate.

Finishing off
- Reinstall seat in car.
- Cars with SIPS airbag: remove the safety device.
- Replace battery negative lead.