Right Front Motor Cable Replacement

WARNING: Seats with SIPS bag must always have the transport safety device installed in order to avoid accidentally activating the system when working on the seat.


Caution: While carrying out the following operations take care not to alter the position of the seat guide rails relative to one another. If the rails are moved then it will not be possible to reinstall the seat in the vehicle.


Removing

Preparations
- Make a note of radio code if anti-theft coded radio is installed.
- Remove battery negative lead.
- Cars with SIPS airbag: Install the transport safety device for the SIPS Airbag.
- Remove seat from car.
- Turn seat upside down and place on a clean surface.

Removal of brackets




- Disconnect connector C on the control module.
- Undo the four screws.
- Remove brackets with the three motors.


Removal of right bracket




- Remove right bracket which is secured by six screws.

Removal of drive cable to front motor




- Remove drive cables from motor and drive gear.

Reinstalling

Replacement of drive cable to front motor




- Reinstall drive cables in drive gear and motor.
- Reinstall right bracket.

Reinstalling brackets
- Reinstall brackets with motors.

Finishing off
- Reinstall seat in car.
- Cars with SIPS airbag: remove the safety device.
- Replace battery negative lead.