Y. Engine Speed RPM Sensor, Replacement

Y. Engine speed RPM sensor

Y1

Remove:







- Battery
- Air cleaner housing ACL complete with intake pipe.
- Battery shelf

Detach:
- ACL bracket.



Y2

Separate transmission connector halves.






Remember rubber gasket.

Detach connector from transmission.
Remove cable clamps around cable harness and rubber grommet.

Remove sockets from connector casing.
Insert screwdriver between casing and socket and press catch in. Press sockets from casing.



Y3

Remove socket for rpm sensor cables.






2-pin, pins 16 and 17.



Y4

Clean thoroughly around sensor







Remove sensor

Install new sensor

Rub some vaseline on sensor 0-ring.
Torque: 5.5 Nm (4.1 ft.lbs).



Y5

Reconnect connector halves.







Ensure that rubber seal is in position.
Install cable clamps round cable harness and rubber seal.

Reinstall connector on transmission.

Plug in connector from car
Remember rubber seal.



Y6

Reinstall:






- ACL bracket.
- Battery shelf
- ACL housing with intake pipe and connections
- Battery



Y7

Check that DTCs have been cleared.
See section On-board Diagnostic System, Diagnostic Test Mode l. Testing and Inspection