DTM 4 (Settings)

Inputs:

Use DTM 4 to reset data stored to switch on service reminder lamp. The service function should be erased at each service. This mode is also used to change the transmission rate when reading off DTCs using a ST.

Entering Settings Manually:

Settings:

- Switch ignition on.
- Select DLC A Terminal 7. General Information
- Push button four times, briefly but firmly. You are now in DTM 4.
- When the LED comes on and stays on, the system is ready for entering codes.
- Enter first digit with LED on.
- LED will now go out: wait until it comes on and stays on again, then enter second digit.
- Repeat for third digit.
- Wait for response from control module (LED flashing several times in succession).