M. Gear Position Sensor, Inspection/Adjustment

M. Gear position sensor, inspection/adjustment

Special tool: 999 5475

M1

Make sure gear shift is set to position N

Remove:







- Battery
- Battery shelf
- Air intake manifold



M2

Remove:







- Transmission cable from rod arm
- Selector lever

Install 9995475 on control shaft.

Check that shaft is set to position N.

The indentation on the tool should align with the marking on the gear position sensor.



M3

Adjustment:

Remove:








- Dipstick pipe bracket.
- Gear position sensor screws

Rotate the gear position sensor so that the mark on the switch aligns with the indentation on the tool. Tighten sensor screws.

Torque: 25 Nm (87 ft. lbs)


M4

Reinstall bracket for dipstick pipe.







Make sure that the 0-ring on the pipe is in place. Torque to 25 Nm (15 ft. lbs).

Install:

- Rod arm on control shaft. Torque to 16 Nm (15 ft. lbs).
- Transmission cable on rod arm with washer and lock clips.
Apply grease 1161241-3 sparingly to the rod arm pin.



M5

Install:







- Air intake manifold
- Battery shelf
- Battery. Reconnect battery leads.



M6

Check that DTC's have been cleared.

See On-board Diagnostic System section, Diagnostic Test Mode 1.
Test position of gear position sensor with Diagnostic Test Mode 2. Testing and Inspection