Excessory Drive Belt - Noise
DATE: April 1995SECTION: 2
GROUP: 21
NO.: 813
New extension piece for right front fender liner 850
REFERENCE: TP 8201201, SECTION 8 (02-86, 88) INTERIOR, EXTERIOR; 850 1993 -
THIS BULLETIN SUPERSEDES 21-813 DATED MARCH 1994.
New extension piece for right front fender liner
Splashes of water may occasionally penetrate the space between the sub-frame and fender liner, resulting in intermittent accessory drive belt noise. A new liner extension piece has been produced to further improve protection against splashing. The new component (P/N 9154415-5), which replaces the earlier extension piece, is suitable for all 850s and was introduced on production models in January 1994. The earlier extension piece can be replaced by the new type.
Install extension piece on right front fender liner
Remove plastic nut (A) and bend out wing liner. Remove existing extension piece. Methods of attachment differ; pop rivets, if used, must be drilled out while other staples may be torn loose.
New component has four molded mounting tabs (B). Tabs should be located alternately on outside arid inside of liner.
Fit extension piece on fender liner and reinstall liner in position.
Push extension piece towards rear to position behind control arm mounting.
Refit plastic nut and check that extension piece is located securely.
WARRANTY STATEMENT:
Claims may be submitted under the New Car Limited Warranty when a manufacturing defect is present using claim type: 01
Op. # Labor description Time allowance
82915-2 Extension offender liner, right side, install 0.2 hr