Hydraulic Control System Installation

1. Connect throttle cable to throttle cam.
- Mount control system in position and insert screws loosely.
- Ensure that gear selector cam spigot is seated in selector valve groove.

Hydraulic Control System Without Lock-up:

NOTE: Illustration shows control system without lock-up.

Hydraulic Control System With Lock-up:

NOTE: Illustration shows control system with lock-up.

Control System Screws:

2. Remove retainer 5076 and tighten screws. Tighten alternately. Torque: 8-12 Nm (6-9 ft.lb).
3. Connect kickdown cable to throttle pulley. Adjust cable. refer to "Installation". Service and Repair

Oil Strainer:

4. Install oil strainer and tighten screws. Torque: 56 Nm (3.5-4.5 ft.lb).
5. Install particle magnet(s). Magnets are installed under strainer in sump.
6. Install control system oil pipes.

NOTE: Three pipes in transmission with kickdown inhibitor.

7. Install oil sump with new gasket. Torque: 4-5 Nm (3-3.5 ft.lb).
8. Install fluid filler tube. Torque: 80-100 Nm (59-74 ft.lb).
9. Fill transmission with fluid.