Removal

Cable To Thrtle Pulley Connection:

1. Disconnect cable from throttle pulley.
- Pull cable slightly out of sleeve in engine compartment.
- Cut off cable between stop and cable tensioner.
- Remove cut section from throttle pulley.
- Remove cable tensioner and sleeve from mounting bracket.
2. Drain transmission fluid by removing drain plug.
- Units without drain plug, disconnect filler tube from sump.
- Remove sump and gasket.

WARNING: Fluid may be extremely hot if car has recently been driven.

Cable In Gearbox:

3. Disconnect cable from gearbox. Use snipe-nose pliers to pull out a loop of cable and jam throttle cam with a screwdriver.
4. Disconnect cable from throttle cam. Clean outside of gearbox around cable sleeve and remove sleeve.