Sun Roof - Repairs and Adjustments
83volvo02SECTION GROUP NO.
83 5
DATE October, 1983
RE: Sun Roof
Repairs and Adjustments
760 GLE
THIS SERVICE BULLETIN REPLACES 83 5 DATED SEPTEMBER, 1983. APPLICABLE TO THE U.S. AND CANADIAN MARKETS.
New types of sealer moulding have been introduced in production to obtain a better fit between the sun roof and roof panel. Parts required are 1334390-0 seal moulding front and 1334725-7 seal moulding rear.
The control mechanism is now marked in production to indicate its position when the sun roof is closed.
The instructions for positioning the electric motor have been revised.
PROCEDURE:
Set the control mechanism in a position which corresponds to a closed sun roof.
Make sure that the center of the pin is in line with the assembly mark.
SET THE ELECTRIC MOTOR
Run the motor backwards (sun roof opens) to the stop position.
Run the motor forwards to the stop position (sun roof closes). Each operation should take 4-5 seconds. Make a mark where the motor stops.
Continue to run the motor forwards to the stop position (ventilation flap open).
Run the motor backwards again to close the roof. This should take 1-2 seconds. Make a mark where the motor stops.
If the motor does not stop in the same position as before, set it between both marks. (Press the center screw and turn with a screwdriver).
INSTALLING MOTOR
If it is difficult to install the motor, move the control mechanism 1-2 mm forwards on one side. If this does not help, return the control mechanism to the assembly mark and move the control mechanism on the other side 1-2 mm forwards.
Recheck the operation of the sun roof.
Warranty claims may be submitted during the new car warranty period under Operation 836333 Time Allowance 0.3 hours.