Engine Coolant Temperature Sensor G62
Engine Coolant Temperature Sensor G62
Requirement:
• Engine is cold.
Removing
- Briefly open the coolant expansion tank cap to reduce the residual pressure in the coolant system.
- Remove the engine compartment cover. Refer to => [ Engine Compartment Cover ] Service and Repair.
- Remove the front engine cover - 1 - upward.
- Disconnect the connector - 1 - from the Engine Coolant Temperature (ECT) sensor.
• Place a cloth underneath to catch any coolant leaking out.
- Remove the retaining clip - 2 - and the ECT sensor.
• Ignore the - arrow -.
Installing
Installation is carried out in the reverse order while noting the following:
• Replace the O-ring.
• To prevent coolant loss, immediately insert the new ECT sensor into the connection.
- Check the coolant level.