Rear Suspension

Motor Pump Assembly

Special tools, testers and auxiliary items required

• Torque wrench (V.A.G 1331)

• Vehicle diagnostic, test and information system (VAS 5051)

Removing

- Depressurize hydraulic system using (VAS 5051).

- Remove rear left wheel housing liner.

- Remove hydraulic lines - 1 - and nuts - arrows -.





- Removing rear left tail lamp.

- Remove adapter from body, remove bolts - arrows - to do so.





- Remove C-pillar trim from left side..

- Remove roof end strip..

- Remove D-pillar trim..

- Remove rear lock carrier cover..

- Remove storage area floor..

- Remove rear left backrest. Refer to

- Remove left side panel trim..

Vehicles with Auxiliary Heating and A/C Unit

- Remove heating and A/C unit.

Continued for All Vehicles

- Disconnect electrical connections between vehicle electrical system and engine pump assembly

- Remove bolts - arrows - and remove engine pump assembly from vehicle.





Installing

Installation is performed in the reverse sequence.

After installing, hydraulic system must be bled using (VAS 5051).

- Bleeding hydraulic system, refer to => [ Separable Stabilizer Bar, Bleeding ] Separable Stabilizer Bar, Bleeding.

Tightening Specifications