Converter With Socket, 12V-230V - U13

Converter With Socket, 12V, 230V U13, Removing And Installing







Socket 12 V, 230 V -1 - is installed in side wall trim on right side in luggage compartment. Converter is installed on a retainer on right rear wheel housing and is joined permanently to the socket.

CAUTION:
- In the Converter with Socket, 12V, 230V U13 housing are capacitors which maybe charged with a residual voltage.
- There is a danger of electric shock.
- The housing of Converter with Socket, 12V, 230V U13 must not be opened under any circumstances.

Special tools, testers and auxiliary items required







- Trim removal wedge 3409

NOTE:
- When removing and installing components in a visible area (switches, covers, trim, etc.), mask off the areas at which a prying tool (trim removal wedge 3409, screwdriver) will be positioned, using commercially available adhesive tape.
- No repairs may be performed on the harness connector, on the wires and the 230 V - socket.
- If there is a fault at harness connector, at wires, at 230 V -socket or in the converter, the complete unit must always be replaced.

Removing:
- Switch off ignition, switch off all electrical components and remove ignition key.
- Remove right side panel trim in luggage compartment.







- Push the two retaining tabs - 3 - outward in - direction of arrow - and pull socket - 2 - toward rear out of socket mount -1 - in side trim.

NOTE: Socket mount is joined permanently to the side trim.







- Disengage and disconnect harness connector -1 - at converter - 2 -.
- Remove mounting bolt - 3 - and remove converter upward from bracket.

Installing:
Install in reverse order of removal, noting the following:
- When inserting converter, make sure that guide rails on converter sit correctly on bracket and converter fits securely after tightening the mounting bolt - 3 -