Air Cleaner Housing: Locations

Air Filter, Assembly Overview

Connection to compressor for air suspension, separating







1 - Intake tube
2 - Spring-type clip
3 - Intake tube
4 - 6 Nm
5 - Mass Air Flow (MAF) Sensor G70 with Intake Air Temperature (IAT) Sensor G42
6 - Seal
- Replace if damaged
7 - Air filter upper part
- On right side with connection to Secondary Air Injection (AIR) Pump Motor V101
8 - Filter element
9 - To Secondary Air Injection (AIR) Pump Motor V101
10 - Air duct
- Secured to lock carrier
11 - Rubber bushing
- Clipped into longitudinal member
12 - Air filter lower part
- To remove right lower part of air filter, the bracket for the right engine cover must be removed
13 - 10 Nm
14 - Connection from compressor for air suspension
- Removal







Removing bracket for right engine cover
- Press in retaining tab - 1 - from below and pull out bracket in direction of - arrow -.

Connection to compressor for air suspension, separating







- Separate connecting line at right air filter - arrow - as follows:
- Carefully pry off green circlip - 1 - using a screwdriver. Then press clamping ring - 2 - in direction of - arrow -.







- Pull only loosened line - B - from connection - A - at air filter.