Multiple Junction Connector: Service and Repair

Electronics Box In Left Plenum Chamber, Removing And Installing

Removing:

CAUTION: When disconnecting and reconnecting battery terminals, observe all applicable Notes and torque specifications, as well as instructions on performing OBD program and electrical system function checks as specified. Not adhering to proper disconnection sequence will result in deactivation of Main Battery Switch -E74- and subsequent damage to electrical system components.

- Disconnect battery.
- Remove drivers side wiper arm.
- Remove passengers side wiper arm.
- Remove plenum chamber cover.







- Remove bolts - arrows - and remove E-Box cover.







NOTE: The number of electrical connections -2- can deviate from the illustration depending on vehicle equipment.

- Disconnect electrical connections - 2 - and remove housing gasket -1- upward out of E-Box.







NOTE: The number of electrical connections -3- and number of threaded connections -1 - can deviate from the illustration depending on vehicle equipment.

- Loosen threaded connections -1 - of supply wires and remove them from connecting pins.
- Unclip connector - 2 - from E-Box.
- Disconnect electrical connections - 3 - and remove housing gasket - 4 - upward out of E-Box.
- Remove bolts - arrows - from upper section of E-Box.







- Remove upper section of E-Box upward.
- Unclip lower section of E-Box from vehicle.

Installing:
Install in reverse order of removal, observing the following:







- Insert securing rubbers -1 - into lower section of E-Box.







- Clip lower section of E-Box with securing rubbers on pins - arrows - on vehicle.

NOTE:
- Sleeve seals for wires must be inserted into guides of E-Box.
- Wires must not be pinched when assembling upper and lower sections of E-Box.