Fuel Tank With Assembly Components, Disassembling and Assembling

Fuel Tank With Assembly Components, Disassembling And Assembling







1. Fuel filler tube
2. To EVAP canister
3. Fuel tank
- Discharge.
4. Flange
- Right side
- Note installation position at fuel tank, see Fig. 1
- With fuel filter: Fuel filter, disassembling and assembling
5. Locking ring, 145 Nm
- Use wrench T10202 to remove and install
- Check for secure fitting
6. Fuel pump (FP) unit
- Left side
- Checking Fuel Pumps (FP)
7. Fuel Supply Sensor 3 -G237-
- Left side
8. Vacuum booster
- Left side
- Is clipped in at bottom of container
9. Protective cover
- For fuel tank, bottom
10. Tension strap
- Note installed position
- Check for secure fitting
11. 20 Nm plus an additional 1/4 turn (90 degrees )
12. Protective cover
- For fuel tank, top
13. Vacuum booster
- Right side
- Is clipped in at bottom of container
14. Fuel pump (FP) unit
- Right side
- Checking Fuel Pumps (FP)
15. Sender for fuel gauge -G-
- Right side
16. Flange
- Right side
- With gravity valve
- To remove fuel tank, fuel tank may be maximum half full.
- Note installation position at fuel tank, see Fig. 1
- Individual components, see Fig. 2
- With fuel pressure regulator: checking fuel pressure regulator, checking fuel pressure regulator and residual pressure
17. Vent line
- Check for secure fitting
18. Expansion tank
19. Gravity valve
20. To pressure retaining valve







Fig. 1 Installation position of flange of Fuel Pumps (FP) units
- Install flange right or left with marking in direction of travel (arrow).







Fig. 2 Individual components at flange, right side
1. Electrical connection for Fuel Pump (FP) and sender for fuel gauge
2. Fuel pressure regulator (4 bar)
checking, checking fuel pressure regulator and residual pressure
3. Ground (GND) wire
Check for secure fitting
4. pressure regulator inlet (from fuel filter)
5. Connection to Fuel Pump (FP) unit right and left (without pressure)
6. Gravity valve