Oil Seals For Cover, Installing

Oil seals for cover, installing

Note:
^ The cover can only be removed or installed with the engine removed.





1. Wiring router
^ For wiring harness

2. 8 Nm

3. 8 Nm

4. Camshaft position (CMP) Sensor 2 G163
^ For exhaust camshaft
^ Before disconnecting, mark allocation of connector to component

5. Chain tensioner, 40 Nm
^ Only rotate engine with chain tensioner installed

6. Oil seal
^ Replace if damaged or leaking

7. 8 Nm

8. Oil seal
^ Replace if damaged or leaking
^ Installing

9. Bracket
^ For After-Run Coolant Pump V51
^ For Evaporative Emission (EVAP) Canister Purge Regulator Valve N80

10. Coolant thermostat housing
^ Coolant hose connection diagram Coolant hose connection diagram

11. 23 Nm

12. Oil seal
^ Replace if damaged or leaking

13. Cover
^ Prepare cylinder head gasket for installation

14. Camshaft Position (CMP) Sensor G40
^ For intake camshaft
^ Before disconnecting, mark allocation of connector to component

15. O-ring
^ For oil channel seal
^ Replace
^ Oil before assembling





Preparing cylinder head gasket for installation
Special tools, testers and auxiliary items required
^ Sealant AMV 174 004 01
^ Sealant AMV 176 501

Work procedure
- Clean old sealing compound from the 3 mm holes in the cylinder head gasket - arrows -.
- Fill 3 mm holes in cylinder head gasket with sealant AMV 174 004 01 and coat sealing surface on cover and sealing flange with sealant AMV 176 501. Install the cover immediately!

Note:
^ With the cylinder head installed only half of the holes in the cylinder head gasket are visible.

Oil seals for cover, installing

Special tools, testers and auxiliary items required





^ Fitting sleeve 3378





^ Fitting sleeve 3253/6 from wheel bearing assembly set 3253

Installing
- Do not lubricate seal.





- Install seal with fitting sleeve 3378 in cylinder head cover - 1 - and pull in flush with fitting sleeve 3253/6 from assembly device 3253.