Rear Engine Plate: Service and Repair

Crankshaft Sealing Flange, Flywheel Side

Special Tools and Workshop Equipment Required:
- Pulling Fixture -T10122-

Sealing Flange, Removing

- Remove the transmission, please refer to: Vehicle/ Transmission and Drivetrain/ Automatic Transmission/Transaxle/ Service and Repair/ Service and Repair or Vehicle/ Transmission and Drivetrain/ Manual Transmission/ Service and Repair/

- Remove flywheel / driveplate, please refer to: Vehicle/ Transmission and Drivetrain/ Flywheel/ Service and Repair/ Procedures or Vehicle/ Transmission and Drivetrain/ Driveplate/ Service and Repair/ Procedures

- Remove upper part of oil pan, please refer to: Vehicle/ Engine,Cooling and Exhaust/ Engine Lubrication/ Oil Pan, Engine/ Service and Repair/ Service and Repair.

- Unscrew sealing flange.

Sealing Flange, Installing

NOTE:
- Do not additionally oil or grease sealing lip of oil seal.
- If the sealing flange was supplied with a support sleeve, then the support sleeve can be also used for the installation.

- Clean sealing surfaces. They must be free of oil and grease.

- Before installing, remove oil remains from end of crankshaft with a clean cloth.





- Connect the assembly sleeves -T10122/1- and -T10122/2-.

- Slide the sealing flange -A- with its outer side on the assembly sleeves.

- Disconnect the assembly sleeves.





- Position the sealing flange -A- with the assembly sleeve -T10122/2- on the crankshaft and slide the sealing flange onto the crankshaft pin.

- Tighten the mounting bolts to 10 Nm.

The rest of the assembly is basically a reverse of the disassembling sequence.