Secondary Air Injection (Air) System Components, Removing and Installing

Secondary Air Injection (AIR) System Components, Removing And Installing







Secondary Air Injection (AIR) Pump Relay -J299-*

1. Combination valve
2. Seal
- Always replace
3. Bracket
- Bolted at cylinder head
4. Seal
- Always replace
5. Bracket
- Bolted at intake manifold
6. 10 Nm
7. To Recirculating valve for turbocharger -N249-
8. From vacuum reservoir/intake manifold connection
9. 6 Nm
10. Secondary Air Injection (AIR) Solenoid Valve -N112-*
- Resistance: 25 to 35 ohms
11. Connector
- 2-pin
- Green
12. O-ring
- Replace if damaged
13. Pressure hose
- Check for secure fitting
- To disengage, squeeze together at front
14. 8 Nm
15. Bracket
- For Secondary Air Injection (AIR) pump motor
16. 8 Nm
17. Secondary Air Injection (AIR) Pump Motor -V101-*
18. Connector
- 2-pin
- For Secondary Air Injection (AIR) pump motor
19. Intake hose
- For Secondary Air Injection (AIR) pump
20. From air filter
21. Connection tube
22. Elbow
- Secure with screw-type clamps or spring clamps
23. Pressure line
24. Connecting piece
- Secure with screw-type clamps or spring clamps

Fig. 1 Secondary Air Injection (AIR) Pump Relay -J299-* (-1-) with fuse -2- in protective housing (engine compartment, left)







NOTE:
- Remove battery Ground (GND) strap if tools are necessary for removal of relays or control modules from the relay carrier.
- Obtain radio code for radios with anti-theft coding before disconnecting battery.
- Check activation of the Secondary Air Injection (AIR) Pump Relay