Intake Manifold Upper Part, Disassembling and Assembling

Intake Manifold Upper Part, Disassembling And Assembling (Vehicles With Engine Code BGD)







1. 8 Nm
- Note different lengths of securing bolts
2. Throttle valve control module -J338-*
- Terminals of sensor and connector are gold-plated
3. Seal
- Replace if damaged
4. Pressure relief valve
- Protects intake manifold from damage by excessive pressure
5. Vacuum hose
- from Positive Crankcase Ventilation (PCV) Heating Element -N79-.
6. Molded hose
- From Positive Crankcase Ventilation (PCV) Heating Element -N79- and cylinder head cover.
7. 5 Nm
8. Upper section of intake manifold
- With intake manifold change-over
9. Expanding rivet
10. Vacuum hose
Vehicles with engine code BDC
- From fuel pressure regulator.
11. To vacuum actuator
- On underside of intake manifold upper part
12. To T-piece
13. Intake manifold change-over valve -N156-*
14. 8 Nm
15. Rubber bushing
16. Warm air collector plate
- With intake manifold support
- With mount for combination valve
17. To Leak Detection Pump (LDP) -V144-
18. To brake booster