Intake Manifold Lower Part, Disassembling and Assembling

Intake Manifold Lower Part, Disassembling And Assembling (Vehicles With Engine Code BGD)







1. Fuel rail
- With bleeder valve for fuel supply system.
2. Sealing cap
3. Vent valve
- For fuel supply system
- Bleed fuel system.
4. Wire routing
- Clipped onto fuel distributor
5. Seal
- Replace if damaged
6. 10 Nm
7. Lower section of intake manifold
- with intake manifold change-over
8. 3 Nm
9. To vacuum actuator
- On front side of intake manifold lower part
10. Intake Manifold Tuning (IMT) Valve 2 -N261-
11. 5 Nm
12. Washer
13. 25 Nm
14. From upper part of intake manifold
15. Seal
- Always replace
16. Connection, supply line
17. O-ring
- Replace if damaged
- Lightly lubricate O-rings with clean engine oil before installing
18. Fuel injectors (-N30- through -N33-)*
19. Retaining clip
- Make sure clip is correctly seated on fuel injector and fuel rail