Air Spring Damper Assembly Overview

Air Spring Damper Assembly Overview





1 Bolt, 30 Nm

• Quantity: 4.

2 Mounting bracket

3 Nut, 60 Nm

• Always replace after removal.

4 Mount

5 Seal

• Always replace.

6 Residual pressure retaining valve, 10 Nm

CAUTION!

• Observe important notes about removal and installation

• If residual pressure retaining valve sticks, the vehicle must be on a hoist and the wheels must rotate freely in order to replace the valve.

• When removing air line, there is the possibility that the residual pressure retaining valve will also be removed.

• If vehicle is not raised with a hoist, vehicle sinks immediately on side where residual pressure retaining valve was removed. There is a strong risk of injury because the arms are clamped.

• Vehicle must remain on hoist until a new residual pressure retaining valve is installed and air spring damper is refilled.

7 Air spring

• Follow repair notes for servicing air spring dampers, refer to --> [ Air Spring Damper Repair Information ] Air Spring Damper Repair Information.

• When the vehicle has been driven 200,000 km, if there is damage to an air spring, it is recommended that the opposite air spring is also replaced.

8 Buffer stop

9 Shock absorber

• Follow repair notes for servicing air spring dampers, refer to --> [ Air Spring Damper Repair Information ] Air Spring Damper Repair Information.

10 Seal

• Always replace.

• Grease with (N 052 150 00).

11 Boot

• Always replace.

12 Clamp

• Always replace.