Releasing and Disassembly Contact Housings

Releasing and Disassembly Contact Housings

• Observe general notes for repairs on the vehicle electrical system. Refer to --> [ Vehicle Electrical System ] Vehicle Electrical System.

• Always use the release tools intended for the releasing process. Under no circumstances may terminals be pulled forcefully out of terminal housings.

• Damaged contact housings must always be replaced. New contact housings may be ordered via OTC Kassel.

• Small screwdrivers may be used as an aid to release the secondary locks.

• Chamber/pin assignment is located partially stamped in on secondary lock or rear side of terminal housing.

• Detailed information on component locations of harness connectors. Refer to wiring diagrams, Troubleshooting & Component locations.

The application of the correct release tools to the respective locks can be found in the table.