Passive Occupant Detection System, Inspecting After an Accident

Passive Occupant Detection System, Inspecting After an Accident

Seat occupied recognition controls automatic passenger airbag deactivation.

This equipment is only installed on vehicles released in the USA.

• Each time passenger airbag and/or belt pretensioner on passenger side is deployed, Seat Occupied Recognition Control Module (J706) basic setting must be performed. Perform basic setting with a diagnostic tester that has "Guided Fault Finding".

• If the seat rails and/or seat pan must be replaced after an accident due to deformation, seat occupied recognition must also be replaced with " seat occupied recognition repair kit". Then, Seat Occupied Recognition Control Module (J706) basic setting must be performed. Perform basic setting with a diagnostic tester that has " Guided Fault Finding".

Perform seat occupied recognition basic setting --> [ Seat Occupied Recognition, Basic Setting ] Component Tests and General Diagnostics.