Selector Shaft Seal, Replacing

Selector shaft seal, replacing, 01V, 5 SPD. A/T (FWD)

Special tools and equipment

80-200 Removal lever:

3385 Thrust piece:

Removing
- Remove multi-function TR switch -F125-.





- Remove selector lever cable from selector shaft lever -arrow-.





- Drive spring pin -1- out of transmission selector lever -2- -arrow- until transmission selector lever can be removed from selector shaft.





- Pry seal out with a screwdriver.

Installing
- Apply ATF to circumference and sealing lips of seal.

Installation position:
Open side of seal faces transmission.





- Drive in new seal until thrust piece contacts stop. Make sure that seal remains straight when doing this.
- Push transmission selector lever onto selector shaft and knock in roll pin.
- Carefully press selector lever cable onto selector shaft lever using a pair of pliers. When doing this, take care not to bend the selector shaft lever, otherwise the selector mechanism will not be able to be adjusted correctly.
- Install multi-function switch.