Muffler: Service and Repair

Muffler assembly and mountings





Note: The exhaust system must be aligned lengthwise at -A- and -C- according to dimensions -b- and -c- go to items -7- and -10-.

1 40 Nm (30 ft. lbs.)
2 Locking clamp
3 Intermediate pipe
4 Bracket
5 25 Nm (18 ft. lbs.)
6 Front and rear muffler
^ Available as separate replacement parts
- Cut connecting pipe at right angle at point -10- go to inset -A
- Connect front and rear muffler with double clamp
^ Slide double clamps toward mark -8- inset -B-
7 Dimension - c-
^ Approximately 10 mm (0.39 inch)
8 Marking for double clamp (to be used when replacing one of the mufflers)
^ Marked three times on pipe circumference
9 Cutting point
10 Dimension -b-
^ Approximately 5 mm (0.20 inch)
11 Marking
^ Marked three times on pipe circumference
12 Retaining ring
13 Bracket
14 20 Nm (15 ft. lbs.)
15 Bracket