Gear Selector Housing

COMPONENT NOTES AND INFORMATION
1 Shift knob
2 Sleeve
- Installing, refer to "Shift Lever and Shift Lever Boot". Shift Lever and Shift Lever Boot
3 Boot
- When removing, lift off with frame from center console
- Installing, refer to "Shift Lever and Shift Lever Boot". Shift Lever and Shift Lever Boot
4 Frame
5 Hex nut
6 Spacer
- Attaches console to gearshift housing -9-
- Remove before removing gear selector mechanism
- Installed between console and gearshift housing -9
7 Gasket
- Between gearshift housing and floor
- Self-adhesive
- Attach to gearshift housing
8 Hex bolt
- For mounting plate to gearshift housing
- Tighten to: 15 Nm (11 ft lb)
9 Gearshift housing
10 Hex bolt
- Quantity: 4
- Tighten to: 25 Nm (18 ft lb)
11 Gasket
- Self-adhesive
- Attach to underside of gearshift housing
12 Gasket
- Install between selector cables and gearshift housing